Eden TERRA NOVA TN110 Guía De Instrucciones Rápida página 6

Before You Plug In
Before you plug in or use your cabinet please ensure you know how to correctly operate it. Incorrect operation or installation may
lead to undesirable results or failure which can be avoided by reading this guide.
Your cabinet has been designed to ensure that it performs time and time again. In order to ensure your cabinet provides years of
service it is important that you protect the cabinet from overheating. In order to do this you should follow a few simple rules that
will help protect your investment.
1. Do not block vents or disable ventilation systems. Your cabinet has been designed with a ventilation system that allows air to
circulate over components inside. Vent holes and ports are designed to ensure your amplifier can perform to its maximum
capacity for the longest time. Blocking and vent holes will not only void your warranty, but will almost certainly reduce the life
of your cabinet.
2. Correct Loading: When setting up your cabinet with an amplifier make sure that the cabinet or combination of cabinets you
are using have enough power handling for your requirements. As a guide, when choosing a cabinet it should have a minimum
of the same power handling as the output of your chosen amplifier at full power. When choosing speakers and heads you
should think about what impedance rig your will use. 2x 8 Ohm cabinets will provide a 4 Ohm rig, but if you are only using a
single cabinet you are best to opt for a 4 Ohm single cabinet.
Remember using a load below 4 Ohms will cause stress on the amplifier, so always make sure your minimum total load never drops
below 4 Ohms.
If you are unsure about any about rig impedances or anything else to do with your amplifier speak to the store where you bought it
from, they will be more than happy to provide you with advice.
6
Quick Start Guide | Terra Nova Cabinets