Publicidad
Idiomas disponibles
Idiomas disponibles
!
These operating instructions are an integral part
of the product, and contain important information
and safety notes. Please store them in a safe place,
where you can find them at any time, and pass
them on to the new owner if you sell the receiver.
1.
SPECIFICATION
Name:
Item no:
Set contents:
Angle of reflected beam ( LEDs)
Current drain:
Input voltage range:
LED outputs:
LED output voltages:
Total output power:
Power of single LED:
Case dimensions:
Size of LEDs:
Socket:
Switched functions:
Weight of control unit:
Total weight incl. all LEDs and
leads:
2.
S
N
AFETY
OTES
!
Please read the instructions before using the receiver.
!
Use the POWER-MULTIlight only for the intended
applications.
! Ensure the power supply is of adequate capacity.
3.
A
PPLIANCE
The POWER-MULTIlight provides an attractive means of lighting
up your model. The module should be connected a battery-pack
(7,4 – 12,6 V) a switched channel is ideal for turning the
POWER-MULTIlight on and off. With a 3-position switch the light
can be switched:
Everything OFF / Navigation lights and anti-collision light ON /
Navigation lights, anti-collision light and landing light ON. If
connected directly to the power source / battery all functions are
permanently ON.
Installing the system in a foam model: use a sharp knife to cut a
slot to house the LED cable. Apply adhesive tape over the slot
once you have pressed the cable into it.
Since the red LEDs operate on a lower voltage, it important to
avoid mixing them up. Note also that only a white or green LED
may be connected to the vacant socket.
If you wish to install the LEDs in detachable components (such
as wing panels), we recommend that you use our extension
leads, as the pins of the POWER-MULTIlight module are not
designed to be constantly connected and disconnected. We
offer the following matching extension leads: 150 mm # 8 5019,
300 mm # 8 5031, 400 mm # 8 5029, 600 mm # 8 5032, 1200
mm # 8 5033.
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
POWER
POWER -MULTIlight
# 73030
control unit, nine pre-wired LEDs (5 x white, 3 x
red, 1 x green), hook-and-loop retaining strap,
operating instructions
110°
!
1.45 A
7.4 ~ 12.6 V
9
Red LEDs: 2.3 V, white LEDs: 3.2 V, green
LED: 3.2 V
4.5 W
500 mW
67 x 41 x 19.2 mm
8 mm Ø, 8 mm high
JST (red BEC socket)
Everything OFF / Navigation lights and anti-
collision light ON / Navigation lights, anti-
collision light and landing light ON. If connected
directly to the power source / battery all
functions are permanently ON
35 g
55 ~ 60 g
- MULTIlight
4.
CE C
ONFORMITY
This device has been assessed and approved in
accordance with European harmonised directives.
This means that you possess a product whose design and
construction fulfil the protective aims of the European Com-
munity designed to ensure the safe operation of equipment.
The detailed CE conformity declaration can be downloaded in
the form of a PDF file from the Internet under www.multiplex-
rc.de. It is located in the DOWNLOADS area under PRODUKT-
INFOS.
5.
D
ISPOSAL
Electrical equipment marked with the cancelled waste
bin symbol must not be discarded in the standard
household waste; instead it should be taken to a
suitable specialist disposal system.
In the countries of the EU (European Union) electrical equipment
must not be discarded via the normal domestic refuse system
(WEEE - Waste of Electrical and Electronic Equipment, Directive
2002/96/EG). You can take unwanted equipment to your nearest
local authority waste collection point or recycling centre. There
the equipment will be disposed of correctly and at no cost to
you.
By returning your unwanted equipment you can make an
important contribution to the protection of the environment!
6.
G
UARANTEE
The company MULTIPLEX Modellsport GmbH & Co.KG accepts
no liability of any kind for loss, damage or costs which are due to
the incorrect use and operation of this product, or which are
connected with such operation in any way. Unless the law
expressly states otherwise, the liability on the part of MULTI-
PLEX Modellsport GmbH & Co.KG to pay damages, regardless
of the legal argument employed, is limited to the invoice value of
those products supplied by MULTIPLEX Modellsport GmbH &
Co.KG which were directly involved in the event in which the
damage occurred. This does not apply if liability is incurred
according to statutory law on account of intentional or gross
negligence.
We guarantee our products in accordance with the currently
valid statutory regulations. If you wish to make a claim under
guarantee, your initial course of action should always be to
contact the dealer from whom you purchased the equipment.
The guarantee does not cover faults and malfunctions which are
caused by the following:
•
Incorrect or incompetent use
•
Maintenance carried out incorrectly, belatedly or not at
all, or not carried out by an authorised Service Centre
•
Incorrect connections
•
The use of accessories other than genuine
MULTIPLEX items
•
Modifications or repairs which were not carried out by
MULTIPLEX or by an authorised MULTIPLEX Service
Centre
•
Accidental or intentional damage
•
Defects due to normal wear and tear
•
Operation of the unit outside the limits stated in the
Specification
# 7 3030
D
ECLARATION
N
OTES
/ L
E
IABILITY
XCLUSION
Seite 2/6
Publicidad
