Jata calor C204TT Instrucciones De Uso página 8

WALL ASSEMBLING
• Attention: the minimum distances for wall mounting:
From the floor: 10 cm.
From the lateral walls: 15 cm.
• Warning: all objects (table, shelf etc.) must be over the appliance.
• Turn the appliance and insert the two lower supports (9) at the end of the grille to the back side of the appliance
(Fig. A). Next screw them.
• To fix the appliance to the wall:
- Place the upper support (8) against the wall and mark the holes. The distance between the holes must be
310 mm. (Fig. B)
- Perforate the wall on the marked holes and insert the wads.
- Next fix the supports to the wall with the two largest screws.
- Place the radiator tilting it slowly and making coincide the supports (8) with the windows placed in the
back side of the appliance and press it down slowly to leave it correctly fixed.
After the appliance is fixed correctly, mark again in the wall the holes corresponding to the lower supports.
- Remove the appliance from the wall, make two holes on the marked points and insert the wads.
- To finish, place again the appliance onto the support and screw it with the lower supports to
the wall (Fig. C).
INSTRUCTIONS OF USE
FUNCTIONING WITHOUT TIMER
• The timer functioning selector (7) must be placed in "
• Plug the appliance into the mains.
• Turn the thermostat knob (1) clockwise to its maximum position (MAX).
• Select the desired power with the power switches (2) having in mind:
Power switch 750 W: Minimum power.
Power switch 1.250 W: Medium power.
Power switches 750 W + 1.250 W: Maximum power.
• When the room reaches the desired temperature, turn the thermostat knob (1) anti-clockwise until the indicator
or indicator lights of the switches switch off which indicates that the thermostat has been disconnected.
• Leave it in that position and the thermostat will maintain the selected temperature with the consequent energy
saving.
• When you do not use the heater, switch off the switches, place the thermostat knob in the off position and
unplug the appliance from the main.
FUNCTIONING WITH TIMER
• The convector timer allows to program the heater to be switched on and off in the previously selected hours.
• Place the power selector (7) in
• Turn in the arrow direction to place the timer in the actual time, making coincide the time with the
indication .
• Slide down the pins that correspond with the time or times that you desire to be the appliance switched off
and slide up the pins that correspond with the time that should be on. Having the appliance plug to the mains
and the knobs activated, the convector will switched on and off in the programmed period.
TURBO FUNCTION
• The turbo function has a double use because it can work as a fan giving cold air or hot air.
• Having the power switches (2) in off position and the functioning selector (7) in "
switch (3). The air emitted from the left side of the grille will be cold.
• On the contrary if the convector is activated giving hot air, pressing the turbo switch (3), the hot air also goes
out from the left side of the grille.
"NO-FROST" FUNCTION
• Being the thermostat knob (1) in the minimum position (MIN) and at least one power switch (2) activated, the
radiator switches on automatically when the temperature of environment falls bellow 5° C.
" position.
position.
8
" position press the turbo