Complete The Installation - Gladiator GARF19XXYK00 Instrucciones De Instalación

Lower Rear Corner
A. Refrigerator/freezer rear unit hole
B. Caster bracket
11. While holding the bracket in place, insert the four ³⁄₈" hex-head
unit bolts removed in Step 9 into the front holes and the ¹⁄₂" hex-
head unit bolts into the rear holes. Fasten the bolts, but do not
over-tighten.
NOTE: If the casters are not installed to the caster bracket in the
correct positions you will not be able to insert the hex-head unit
bolts into the front and rear unit holes.
12. Insert two of the ¹⁄₄–20 x 1¹⁄₄" self-tapping hex-head bolts and
lock washers into the two caster bracket holes in the side as
shown. Push the caster bracket against the bottom of the
refrigerator/freezer and tighten the bolts using a ³⁄₈" socket
wrench.
A. Caster bracket holes
13. Repeat steps 10 to 12 for the other caster bracket.
4
A

Complete the Installation

1. Lock the front casters.
NOTE: Locking the casters will help prevent the refrigerator/
freezer from moving while it is being lifted.
2. Insert a small piece of cardboard between the caster brake and
A
the floor. This will help prevent the brake from rubbing on the
floor.
B
3. Stand the refrigerator/freezer upright.
4. Replace the base grille by placing the metal clips in the openings
in the metal panel and rolling the grille downward until it snaps
into place.
5. Unlock the casters and move the refrigerator/freezer into its final
location.
6. Lock the casters.