Maxspect Aeraqua Duo AD600 Manual De Usuario página 10

3. Controller
EN
Controller Unit Introduction
Turn ON/OFF the Skimmer
Press the ON/FF button over 3s can turn on or off the appliance. While the appliance is turned
off, the appliance will stop working, the indicators and OLED screen of the controller will be
shut down. However, if the appliance is connected to an ICV6 (sold separately), it can be
activated by the SYNA-G App.
Initialize the Skimmer
Before putting the skimmer into operation, there are some basic settings you need to do for
the system.
1.
3.
Note: Delay Time allows you to set a duration for the appliance, when the appliance is connected to power
it will keep stop working for a period of time and then starts to work. This is useful especially when the
appliance is restored to power after power failure to avoid the overflowing of the collection cup. Available
settings: OFF, 10s(default), 30s, 60s, 120s, 180s, 300s.
System Setup
To enter the System Setup page, first disconnect PSU from the controller unit, then press and
hold the control dial and reconnect the PSU. Keep on holding the control dial until the
system setup page is shown on OLED monitor.
1. Upgrade or downgrade system's firmware.
2. Reset user setting to default factory setting.
3. This function should only be conducted by the users when told by authorized dealer or customer
representative to perform certain test on the appliance.
4. Model Selection.
5. Reboot the system to the normal operating status.
8
Power Indicator
Manual Mode Indicator
Automatic Mode Indicator
Set system clock.
Set the delay time before the appliance getting into
operation.
Enter setup page.
Set parameter.
Setting Indicator
ON/OFF, Feed Mode Button
Mode Switch, Setup Button
2.
Switch between settings.
4.
Save the setting.
Switch between functions.
1.
2. Apply the function.
Operation
Control Dial