GE JT3800DH5BB Instrucciones De Instalación página 4

2 E
SECURING UPPER MICROWAVE/ADVANTIUM OVEN TO CABINET
For double oven with microwave or Advantium upper ovens. Secure a wooden cleat to side of cabinet
so that the upper oven can be secured to the cleat with provided screws
27" Cabinet requirements
• No shims (or cleats) required when cabinet is in minimum
width condition.
• If cabinet is at maximum width condition, add wood
shims to bring cabinet to minimum condition.
30" Cabinet requirements
• No shims (or cleats) required when cabinet is in minimum
width condition.
• If cabinet is at maximum width condition, fix the wood
cleats as shown in illustration.
2 F
CUTOUT FOR INSTALLATION OVER A WARMING DRAWER
NOTE: Install the oven only with specific models listed on the label located on top of the oven.
NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct the required interior depth and height.
When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly
grounded receptacle must be installed. Refer to installation instructions packed with
the Warming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Continue to Section 4
1.5"
6.375"
3.0"
Wood Cleats
27.5"
Cleat locations on 30" cabinet
with maximum cutout condition
Per Warming
Drawer
Requirement
3
PEDESTAL RAIL INSTALLATION (30" DOUBLE OVENS ONLY)
A. Place one pedestal rail on each cabinet runner or centered on opposite side of solid cabinet bottom
flush with side of cabinet opening. Locate each rail so that front of rail is behind front cabinet
opening.
B. Drill pilot holes and attach rails to runner or bottom of cabinet with provided hardware.
4 A
DOOR REMOVAL (RECOMMENDED)
NOTE: Door removal is not a requirement for installation of the product but is an added convenience.
To remove the door:
A. Open the oven door as far as it will go.
B. Remove hinge bracket from front frame and set aside. The hinge bracket must
be replaced for proper door functionality when door is reinstalled.
C. Push both hinge locks down toward the door frame to the unlocked position.
This may require a flat-blade screwdriver. DO NOT LIFT THE DOOR BY THE
HANDLE!
D. Place hands on both sides of the door and close the oven door to the removal
position (approximately 1"–2" [2.5 cm–5.1 cm] from the closed position).
E. Lift the door up and out until the hinge arms clear the slots.
NOTE: The oven door is very heavy. Be sure
you have a firm grip before lifting the oven door off the hinges. Use caution
once the door is removed. Do not lay the door on its handle.
This could cause dents or scratches.
Hinge Unlocked Position
Hinge Slot
Hinge Arm
Hinge Bracket
Hinge Clears Slot