Temperature Mode; Demonstration Mode - Basic XL BXL-JC10 Manual De Uso

After the above settings are completed, press the UP key to start timing and the number of seconds
set starts decreasing. When timing reaches 0 seconds, the set number of minutes starts decreasing.
When it reaches 0 minutes, the set number of hours also starts decreasing. When timing reaches
00:00:00, the chords start playing, the product starts rotating and the coloured lamp starts giving out
dynamic and coloured light. It stops automatically after one minute.
Setting range: 0-23 for hour, 0-59 for minute and 0-59 for second.
In the setting mode, press the MODE key twice to return to time mode.
In the course of time counting, press the UP key to pause time counting and press again to resume. If
time counting is paused, press the DOWN key to clear the setting and reset it to zero.

Temperature mode:

Displays current ambient temperature. In time display mode, press the SET key briefly to shift between
Centigrade temperature and Fahrenheit temperature. Normal range of measurement: 0-50°C
(32-122°F)

Demonstration mode:

In any mode, press the TEST key to enter demonstration mode. The chords start playing, the product
starts rotating and the coloured lamp gives out dynamic and coloured light.
Reset: In case of abnormal display, press the RE key to reset to the default value.
Power supply and replacement of batteries: (2 sets of batteries should be inserted as per the
following steps for a newly purchased clock).
Two sets of batteries are used for the power supply of this product. 4 pieces of 1.5 V AA batteries are
used for the power supply of the motor and lamp and 2 pieces of 1.5 V AAA batteries are used for the
power supply of the display and audio parts.
Replacement of 1.5 V AAA battery: If the product is used for a long time, the display is weak, the alarm
ring sound lacks fidelity or is intermittent or mute, it indicates that the unit lacks electricity and the
batteries need to be replaced with 2 pieces of size 7 batteries. Remove the upper cover of the ball part
of the product, remove the battery cover and insert 2 pieces of new size 7 1.5 V batteries properly.
Replace the battery cover and upper cover of the ball part properly.
Replacement of 1.5 V AA battery: If the product is used for a long time, the alarm ring lacks fidelity, the
light is dim when pressing TEST to enter demonstration mode, the motor rotates very slowly or the
motor does not rotate when power is on, it indicates that the unit lacks electricity and the batteries
need to be replaced. Remove the upper cover of the ball part of the product, remove the battery cover
of the rotating part in the middle and insert 4 pieces of new 1.5 V batteries properly. Replace the
battery cover and upper cover of the ball part properly. (See installation diagram of batteries at the
back).
Caution:
The product can jump rapidly when the alarm goes off and if "TEST" is pressed. The product will move
rapidly or jump while rotating, so please do not put it in a very high place to ensure that the product will
not be damaged when it is dropped.
Step one
Gently loosen the buckles with your hand as shown in 1 (5 buckles in all).
Remove the upper cover as shown in 2.
3