Dirna bycool blue line FLAT ADR Instrucciones De Montaje página 25

FLAT
Fasten the fastening supports by tightening the
12
nut until the outer EPDM seal tightening of the
equipment is between 3 and 6mm.
Important: To avoid possible water leaks into
the inside of the cab the EPDM seal tightening
must be adjusted with the base of the Bycool as
indicated in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
12
is between 3 and 6 mm.
Screw (4) M8 nuts to the support and (4) to
13
the base of the Bycool.
EPDM seal
10 mm*
(*) (approx. after tightening)
Base
Support
25
dirna
, s.a.
Check compression
thickness using a tape
measure in the four
corners.
EPDM seal
EN
12
13