ProBreeze PB-H12 Manual De Instrucciones página 5

OPERATING INSTRUCTIONS
Switching On and Setting Temperature
1. Insert the plug into the power socket.
2. Turn the power dial to the desired level:
a. LOW – Low heat (1200W)
b. HIGH – High heat (2000W)
3. Turn the control dial until you hear a click, this will turn the unit on. Continue turning the
dial to your desired temperature. The temperature control dial acts as a thermostat. Once
the room has reached the desired temperature, the unit will switch off.
Fan Only Mode
For fan only mode, turn the power and fan control dial to FAN MODE.
Switching Off
1. Turn the power and fan control dial to the OFF position.
2. Turn the temperature control anticlockwise to the lowest setting.
3. Remove the power plug from the power socket.
Overheat Protection
If the heater overheats, the thermostat built into the appliance will automatically cut off the
power supply to the heater and the heater will turn off. The heater will need to cool down for
10-20 minutes. One the heater has cooled down it can again be used normally. Overheating of
the appliance can occur during improper use or in certain environmental conditions.
Tip-over Protection
When the heater is knocked over or tipped onto its side, the safety switch will automatically cut
off the power supply to the heater. Power will return to normal when the unit has been placed
in an upright position and onto an even surface.
English | 4