DeLOCK 86107 Manual Del Usuario página 3

English
The four LEDs will signal the used pairs of the PoE power source and
the used standard (802.3af or 802.3at).
LED 1 LED 2


X
X


Cable Tester Operation
The Cable Tester can test twisted pair cables and will identify wrong
connections, short circuit and open circuit.
Connect one end of a LAN cable into the RJ45 (or RJ11) port of the
main unit, and the other end into the removable remote unit of the
tester. Turn the tester on by switching to ON for normal speed or S for
slow speed testing. The LEDs will turn on sequentially as below:
Master Tester: 1-2-3-4-5-6-7-8-G
Remote Tester: 1-2-3-4-5-6-7-8-G
If one wire has an open circuit, the light will not turn on.
If the wiring is disordered (e.g. wires 2 and 4 crossed), then the
display will change:
Master Tester: 1-2-3-4-5-6-7-8-G
Remote Tester: 1-4-3-2-5-6-7-8-G
If two or more cables are short circuited, the corresponding LEDs
won't light on the remote unit while the main tester remains normal.
LED 3
X X
X

X 
X 
X

 
LED 4
X 12/36 (Endspan) 802.3af
X 12/36 (Endspan) 802.3at
X 45/78 (Midspan) 802.3af
 45/78 (Midspan) 802.3at
X 12/36 + 45/78 802.3af
 12/36 + 45/78 802.3at
- -
2