Toshiba TEC B-570-QP Serie Manual De Instrucciones página 14

6. LOADING THE MEDIA
4. Put the media on the supply shaft.
5. Pass the media around the damper, then pull the media towards the front of the printer.
6. Insert the ridge of the supply holder into the groove of the supply shaft until the media is fixed. Then turn
the locking ring clockwise to secure the supply holder. This will centre the media automatically.
NOTE: Do not over tighten the locking ring of the supply holder.
7. Insert the media into the paper holders of the media guide, adjust the media guides to the media width,
and tighten the locking screw.
8. Check that the media path through the printer is straight. The media should be centered under the print
head.
Media Guide
NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both
paper holders using the following procedure. Failure to do this may cause a paper jam error.
If you have any questions, please contact your nearest TOSHIBA TEC service representative.
Damper
Paper Holder
Locking Screw
Groove Ridge
Media
Supply Shaft
Media
E6-2
ENGLISH VERSION EM1-33031
6. LOADING THE MEDIA
Supply Holder
Supply Holder
Media Guide
Paper Holder
Print Head
Media
Projection
Fig. 6-3
Fig. 6-4