Charging Instructions - Adalit L2000-L Instrucciones De Uso

1.1. Marking
L2000-L Torch:
L2000-LB Torch:
- The charge of the battery only should be done in a safe area
- Warning to the electrostatic risk of the housing
1.2. Handling and maintenance
For putting into operation subject the torch to a charging cycle with the char-
ger, and then the equipment will be ready for use.
The torch Adalit does not need any sort of systematic maintenance given
that its battery is conceived as being of "MAINTENANCE FREE".
Only the bulbs are subject to being replaced, given that they run down with
use.
It is recommended to make a complete charging cycle at least once per
month.
1.3. Instructions for general use
1. The torch must be kept perfectly clean, special attention being paid, in this
sense, to the lens. The dirt, which may accumulate in the latter, can seriously
impair lighting performance.
To clean the various components the following products should be used:
a) Torch body and head piece:
Household detergent diluted in lukewarm water, or lukewarm soap water, to
be applied with a soft cloth. (Do not submerge the lamp in water.)
Do not use turpentine, cleaning materials with a dissolvent base or chlorised
liquid cleaners (for example, trichlorethylene or solvents with an organic base).
b) Protection lens:
Household detergent diluted in lukewarm water, or lukewarm soap water, to
be applied with a soft cloth.
Do not use any abraseive product or cloth or any component that might
scratch the protection lens.
3. Reflector
This component must be handled with the utmost care, given that any action
on its surface could seriously affect the lamps lighting capacity. We do not
recommend that this piece be cleaned in any way, it being much more advi-
sable to replace the piece if necessary.
2. Mechanical deterioration of any torch component: breakage, wear, etc,
requires the replacement of the component mentioned.
1.4. Assembly and disassembly (see pages 14-15)
a) Headpiece
To reach inside the headpiece in order to check or change some of its con-
tents follow the instructions below:
1. Loosen the closing screw (LC.10) till the non-threaded tip of the screw
comes out from the groove where it was placed.
2. Loosen and remove the bezel (306).
3. Remove the protecting glass (307) and the rubber washer (LB.61).
4. Remove the optical assembly:
ADALIT L2000-L: (LC.13, 34.LDT, 33.LDT, 332.LDN, LC.11, 3260.LDL).
ADALIT L2000-LB: (24307.G, LB.57 (2), 359.E, 360.E).
- Now any component which might need to be changed is accessible.
- It is recommended to replace component LB.61 each time the head piece
is opened.
- To assemble and to close headpiece carry out the operations in reverse.
c) Battery pack and cover
To reach the battery do as follows:
- Loosen and remove the closing screws (209).
- To assemble carry out the operations in reserve.

1.5. Charging instructions

1. Connect the charger to the mains
- Green Led Light On - Red Led Light Off
2. Place the torch body into the charger setting.
Four alternate flickers of the red and green led of the charger indicate the per-
fect working condition of the whole set.
1 - Users instructions
II 2 GD EX ia IIC T4
II 2 GD EX ib e IIC T4
IP65 T85ºC
IP65 T85ºC
5