Installation, Heater Soleado Fuego Plus; Description Of Appliance - Kemper SOLEADO FUEGO PLUS Manual De Usuario

The heaters must be installed in environments
with at least 25% open area
The KEMPER outdoor heater is a modern design product designed to provide comfort in all environments that need to
be fully or partially heated.
The KEMPER outdoor heater is designed to be installed in partially protected environments; for partially protected
environments are those where the heater is not exposed to direct action and penetration of atmospheric precipitation
(snow, rain, hail). We strongly DO NOT recommend installing in direct contact with atmospheric agents.
The KEMPER outdoor heaters are designed and manufactured with the utmost care and attention to the reliability and
importance of design. They have a robust structure in reflective steel, a gas tank seat with panels, safety net on all
sides, high efficiency and durable metal mesh burner, flame heating element and protective glass, adjustable feet.
The installation is simple and in no time the heaters are ready for operation: just place and connect the gas tank after
removing the front panel with the hood.
All the heaters are controlled and adjusted to the correct pressure values (depending on the type of gas and the
country of destination) and finally tested by KEMPER staff. Each heater is affixed to the technical specifications label
(page 6 of this manual), as per regulations, to which the installer should refer to in the event of future interventions.
PREPARATION TO OPERATION - SUGGESTIONS
Below are some IMPORTANT tips:
KEMPER outdoor heaters are supplied with:

- Burner fully assembled and tested at the factory.
- Disassembled but easily to be assembled structure, following dedicated
Pressure reducer + hose available but to be purchased separately.
Pay special attention during the unloading phases and all heater transfer operations due to the

fragility of the glass.
Open the box horizontally on a stable or ground level, then lift the product with the help of a second person

(about 30 kg weight)
Cut the clamp holding the glass tube before switching on

Check that the supply pipe and the gas connection fitting are in accordance with the regulations in force in

the country of use
If there is gas smell with the heater turned on, we recommend that you immediately turn it off and check

for any leakage before using it again.
When replacing LPG gas can you use soapy water or equivalent material to check for leakage of connections

and fittings
IMPORTANT: the first ignition is likely to have a delay in the ignition of the pilot flame; the situation is

normal, and due to the fact that the gas circuit inside has air to dispose; the inconvenience will disappear
with two or three ignitions. To avoid any flame stroke, let it pass about 2 minutes between an ignition and the
next. This could happen again when changing a gas tank: act as above.

MANDATORY, the heater must be carried / moved only when it is cold (people safety and component
protection), taking care to fix the glass tube and remove the cylinder inside.
Page | 26
INSTALLATION,
HEATER SOLEADO FUEGO PLUS
ENVIRONMENTS VENTILATION
WARNINGS

DESCRIPTION OF APPLIANCE

instructions
EN