Publicidad
Idiomas disponibles
Idiomas disponibles
COLUMN ASSEMBLY
1. Attach column to stand with 4 screws as shown.
2. Unscrew / take out height adjustment ring.
3. Slide stand ornament down the column to rest on stand.
4. Pull out the extension pipe and screw / fasten the height
adjustment ring back.
CAUTION: Height adjustment ring must be fully
fastened before the assembly of the motor section
to the stand.
ASSEMBLY INSTRUCTIONS
1. Unscrew the spinner clockwise and the nut counter- clockwise to remove both of them.
2. Set the rear guard in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Discard plastic sleeve on motor shaft.
5. Install the fan blade onto the motor shaft until it reaches the retaining pin.
6. Screw spinner onto motor shaft counter anti-clockwise to blade.
7. Mount the Front Guard and join both Guards together using the Clips.
FAN OPERATING INSTRUCTIONS
1. SPEED REGULATOR:
Speed is controlled by pressing
Buttons of speed regulator on the
Top of body (4 buttons: 0—off, 1—low, 2—medium, 3—high).
2. TIMER
Turn the knob of timer to position which
Set the time you want. The fan will stop
When the time is over. The longest time set is 120 minutes. In case the timer is not use, set the timer
to "ON"
NOTES: The fan can not run if timer is on "0" position
3. OSCILLATING
To make / stop the fan head oscillate, push down / pull up the oscillating
4. TILT ADJUSTING:
P-3
Publicidad
