Assembly Instructions - Texas Hobby 300 Manual De Instrucciones

The factory-fitted control units, such as the gear cable from the handle, must not
be removed or covered.
Always check that nuts and bolts are tight before starting the machine.
Using the machine on steep slopes is dangerous!
Only use the machine in places where it can be operated safely

Assembly instructions

1. Figur 1 shows the contens of the package:
a. Blades.
b. Depthskid with transportwheels.
c. Tiller with cables.
d. Upper steer
e. Usermanual and mountingbrackets with bolts.
f. Grease and manual.
g. Lowersteer, right and left.
2. Mount lower steer using the accompanying bolt and nut. Pay attention to the
steers, rigth and left are different.
Mount steer(a.) on the right, and steer(b.) on the left.
Figur 2, 3.
3. Mount upper steer using the accompanying bolts and handwheels.
Pay attention to the arrows on the plasticbrackets. They must be aligned when
mounting.
Figur 4, 5.
4. Mount thorttlecable(a.) and clutchcable(b.) as shown on the figure.
Figur 4
5. Add the grease on the transmission, as described in this manual.
Figur 6.
6. Mount blades, depthskid and transportwheels using the cotterbolt and pins
Figure 7, 8.
"Be careful of rotating knifes"
9