Installing Your Beverage Center; Unpacking Your Beverage Center; Leveling Your Beverage Center; Installation Limitations - Haier BC100GS Manual Del Usuario

Installing Your Beverage Center

Unpacking Your Beverage Center

1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the beverage center accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the beverage center.

Leveling Your Beverage Center

• Your beverage center has four leveling legs whch are located in the front and rear
corners. After properly placing your beverage center in its finals position, you can
level it.
• Leveling legs can be adjusted by turning them clockwise to raise your beverage
center or by turning them counterclockwise to lower your beverage center. The
beverage center door will close easier when the leveling legs are extended.
Note: If your beverage center has been titlted for any reason, wait 24 hours before
plugging it in.
Install Limitations
• Do not install your beverage center in any location not properly insulated or
heated e.g. garage etc. Your beverage center was not designed to operate in
temperature settings below 55˚ Fahrenheit.
• Select a suitable location for the beverage center on a hard, even surface away
from direct sunlight or heat source e.g. radiotors, baseboard heaters, cooking
appliances etc. Any floor unevenness should be corrected with the leveling legs
located on the front and rear botto m corners of the beverage center.
• Built-in beverage center need to be ventilated from the front. This feature allows
the unit to be built-in in an enclosed area. The bottom front grill should be clear of
all obstructions. This is absolutely necessary for the air to circulate and for the unit
to operate efficiently. The dimensions for installation are as follows (WxDxH).
Note: Remove the upper hinge cover before built-in the beverage center.
English
4