Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the
Sound Module
Installation of the sound module requires the removal of the
insulation attached to the underside of the module. To do this,
it is necessary to remove the sound module from the steering
wheel. For safety reasons, this must always be performed by
an adult.
Remove Sound Module
1. Push sound module down.
2. Turn anticlockwise.
3. Take out the module.
1
Replacing
the Batteries
1. Remove the screw and open
the battery compartment.
1
2. Insert the battery.
Ensure that batteries are connected with
the correct polarity. Do not mix alkaline,
standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries. Do not mix
new and used batteries together!
2
10
Remove Insulation
1. Peel off the insulation (plastic strip)
in a single tugging movement.
Operating the Sound Module
3
1. Button on left: accelerator
2. Centre: horn
3. Button on right: starter
2
1
3
2
The sound module switches off automatically
when not used for approximately 20 seconds.
Safety Information
This symbol, showing refuse bins with a cross
through them, denotes that empty batteries,
rechargeable batteries, button cells, re-
chargeable battery packs, equipment bat-
teries, disused electrical equipment, etc.
should not be disposed of in domestic refuse, since to do so
would represent a hazard to the environment and health. Please
help to preserve environment and health and talk to your children
about the correct disposal of used batteries and disused electri-
cal equipment. Batteries and disused electrical equipment should
be handed in to the usual collection points where they can be
subjected to appropriate recycling. Do not mix dissimilar battery
types or employ new and used batteries together. Empty batter-
ies should be removed from the product. Do not attempt to re-
charge non-rechargeable batteries. Rechargeable batteries should
only be charged under adult supervision. Rechargeable batteries
should be removed from the product before charging. Avoid short-
circuiting the terminals. Only use the batteries recommended or
equivalent types.
the Steering Wheel
1
3. Please ensure that the axle rod
sits firmly in the middle guide rail.
5
5. If there is any play between the
steering wheel and the steering
rod, this can be balanced out using
the spacing washer supplied.
Seat Height
1
Assembling
1. Detach the steering rod from
the car body.
2. Push the rod through the hole
in the base of the vehicle in
the middle of the front axle.
3
4
6
6. Insert screw from the left as shown in
the illustration from the front, and
fasten nut with the spanner supplied.
1. The Carrera Auto has two possible seat
heights. For use by small children, unlock
the upper seat by turning the locks in the
direction of the arrow or to the left and
remove the seat.
GB
USA
1
4. The end of the rod
must be visible at the
top of the vehicle.
11
Publicidad
