Power Supply - babymoov A014407 Instrucciones De Uso

A/ TRANSMITTER
The transmitter operates on power. Connect the
power adapter to the wall outlet.
B/ RECEIVER
1. Operation with battery supplied
The lithium polymer battery is already installed in the receiver. To replace the battery, unscrew the battery compartment cover (22),
and remove the battery.
2. Charge the battery with the AC adapter
Connect the receiver to the mains adapter. When the battery is fully charged, the red light will turn green.
NB. Prior to first use, charge the lithium polymer battery for at least three hours. It is recommended that the device be turned off
during the first charge.
NB. To ensure longer battery life, wait for the battery to fully discharge power before recharging.
Your transmitter and receiver are already connected and ready to communicate. This Babyphone can operate with different video
cameras (up to 4). To connect an additional video camera, follow the instructions below.
The transmitter and receiver are both equipped with a synchronisation button.
1. Turn on the receiver (hold down the power button (12) for 3 seconds) and the video camera to be connected (On/Off button (1)).
2. Press and hold the synchronisation button on the receiver (21) for
3 seconds. You will see the default message "Pairing ..." for the
already connected video camera. Press the receiver synchronisation
button a second time (21) to connect the video camera or cameras
you desire.
3. At the same time, use a pointed object to press and hold the
synchronisation of your video camera (3) for 5 seconds.
4. The two units are connected when the message «OK» appears.
5. If the "Fail" message appears, repeat the steps described above.
12

POWER SUPPLY

RECEIVER CONNECTION TO THE TRANSMITTER
BABY MONITOR TOUCH SCREEN • Instructions for use
PAIR
1 2
Pairing...
3 4
PAIR
1 2
OK
3 4
PAIR
1 2
Fail
3 4
PAIR
1 2
Pairing...
3 4