Radio Reception; Manual Tuning - Aiwa CSD-MD5 Manual De Instrucciones

RADIO RECEPTION

MANUAL TUNING

1
POWER
RADIO FM/AM
1
Press RADIO/BAND* repeatedly to select the
desired band.
When RADIO/BAND is pressed while the power is off,
the power is turned on directly.
* or RADIO FM/AM on the remote control
2
Turn JOG DIAL to select a station.
During FM stereo reception, 1 is displayed.
When using the remote control, press f or g.
10
ENGLISH
k, i
MODE
2
f, g
FM AM
To search for a station quickly (Auto Search)
Keep k or i* pressed until the tuner starts searching for a
station. After tuning in a station, the search stops.
To stop the Auto Search manually, press k or i.
The Auto Search may not stop at stations with very weak
signals.
* or f, g on the remote control
For better reception
FM
Extend the FM antenna and orient it for the best reception.
AM
Keep the AM antenna away from other electrical appliances
and orient it for the best reception.
MO/ST
When an FM stereo broadcast contains noise
Press MODE* so that MONO is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press MODE so that STEREO is
displayed.
* or MO/ST on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
When the power is on, press POWER and RADIO/BAND
simultaneously, then release RADIO/BAND first.
To reset the interval, repeat the above.
NOTE
When the AM tuning interval is changed, all preset stations
are cleared. The preset stations have to be set again.
AM
FM