Publicidad
Idiomas disponibles
Idiomas disponibles
Base plate:
Attention!
Before you start working, check whether the accessory has the exact
position.
Let the machine start running in a safe position for a short time. In
case the machine does not run easily, immediately stop working.
Dust Extraction
Dust which appears during work is harmful to health. For this reason, use
an industrial vacuum cleaner while sanding.
The appropriate Wet/Dry Vacuum Cleaner DSS 25 M / DSS 35 M iP is
available as accessory. Directly connect it to the nozzles which are meant
for it on the dust hood.
Changing the brush rim
Connect the lead cable of the dry-wall sander with the industrial vacuum
cleaner and then connect the extraction hose with dust hood of the sander.
Lead the extraction hose and the cable to the back away from the machine.
Activate the switch-on automatic on the vacuum cleaner.
Switch the machine on and put it carefully on the surface you want to work
on.
Hold the machine with both hands and move it in a linear or rotary way.
For sanding works directly on wall edges you can remove a segment from
the protection hood. This allows working even on spots which are usually
hard to reach.
Remove the nut in the middle of the base
plate by means of the enclosed face
spanner. If necessary, counter hold with a
screw driver in the work spindle.
In case of wear of the brushes (extreme
amount of dust during sanding), the brush
rim has to be replaced.
For this purpose, pull the worn brush rim out
of the guide way and put the new one in the
flute which is meant for it.
Handling
16
Publicidad
