Publicidad
Idiomas disponibles
Idiomas disponibles
Fluke 789
ProcessMeter
Double your power.
The Fluke 787 ProcessMeter was the
first tool to combine a loop calibrator
with a DMM to give process techni-
cians double the power in one tool.
Now it's even better – the ultimate
loop calibration multimeter – the
Fluke 789 ProcessMeter.
The 789 has a display that's not
only twice as large, but also twice as
bright with two levels of backlighting.
And with its built-in, selectable
®
250 ohm HART
resistor, it eliminates
the need to carry a separate resistor
with you.
Now process technicians can do a
lot more while carrying a lot less.
Key new features of the Fluke 789
•
24 V Loop power supply
•
HART mode setting with loop power
(adds 250 ohm resistor)
•
100 % larger dual display
•
1200 ohm drive capability on mA source
•
Enhanced backlight with two brightness
settings
•
0-100 % mA Span Check buttons to toggle
between 4 and 20 mA
•
Infrared I/O serial port compatible with
FlukeView
®
Forms Software Version 2.1
(available Feb. 2003)
•
Externally accessible fuses for easy replacement
Designed and
Conforms to
IEC 1010-1
1000V
N10140
CAT III
™
These 787 features are also included in the 789
•
DMM designed to meet 1000 volt IEC 1010
CAT III standards
•
Precision 1000 V, 440 mA True-rms digital
multimeter
•
Frequency measurement to 20 kHz
•
Min/Max/Average/Hold/Relative modes
•
Diode Test and Continuity Beeper
•
Simultaneous mA and % of scale readout
•
20 mA dc current source / loop calibrator /
simulator
•
Manual Step (100 %, 25 %, Coarse, Fine) plus
Auto Step and Auto Ramp
•
Externally accessible battery for easy battery
changes
R
LISTED
950 Z
Technical Data
Publicidad
