Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Test the new code several times (CODE+"#") before
closing and locking the door.
Changing the 2nd user code (code length:1-8digit code)
1. Open the safe and locate the red reset button on the
inside of the door.
2. Input 0-0 on the keypad, and press the reset button,
there will be 2 beeps and a yellow light will appear for
20 seconds.
3. Before the yellow light disappears enter a new code
and press the "*" key. The new code must be between
3 to 8 digits. If the code is valid, the keypad will beep
twice. If a wrong code has been entered or code entry
has failed, there will be 4 beeps, wait for the yellow
light to disappear and repeat above steps 1-3.
WARNING
Test the new code several times (CODE+"#") before
closing and locking the door.
Security Lockout
If the code is correct, a green light will turn on for 5
seconds. If the incorrect code is entered, a red light
will turn on, followed by 4 beeps. If an incorrect code is
entered three times in a row, the keypad will automatically
lock for 15 minutes.
Override Keys To Open The Safe
In case of a forgotten password or if the battery is drained,
use the override lock system to open the safe.
1. Remove the battery.
2. Locate the plastic logo sticker on the top of the lock pad.
3. Remove the logo sticker to locate the screw under
the lock pad. Note: The logo sticker should be placed
back on the lock pad, so avoid adhesive wear or
placing it on surfaces.
4. Use a Phillips Head Screwdriver to remove the screw
connecting the keypad face to keypad collar.
5. Carefully let the keypad face hang with wires still attached.
6. Locate the override key slot inside the keypad collar.
With the larger notches facing up, insert the key into
the slot. The key may need to be angled slightly for it
to slide in properly.
7. Once the key is snug, turn counter clockwise; then pull
the handle to open the door.
1 and 2 Door Depository Safes
Burglary and Fire Safe
WARNING
• Do not keep the keys in the safe.
• Remove the battery when using the keys.
• Do not pull or tug on keypad face or wires, it is crucial that
the wire stay intact and connected for the lock to operate.
• Global Industrial is not liable for any damages that may
occur to the lock while accessing the override key slot
Reinstalling The Keypad Face
1. Carefully grip the keypad face, holding it so the face is
out and the numbers are right side-up.
2. Reattach to the keypad collar by inserting the bottom
first, so the notch connects. Then carefully press/push
into keypad collar casing.
3. Once snug in place, screw the keypad face back to the
keypad collar and replace the logo sticker.
CAUTION
Be careful with the wiring. Do not pinch wires in between
the keypad face and collar.
2
User's Manual
Publicidad
