11.
Batteries
•
The remote control uses 1 battery type 3V lithium CR2025 battery (included).
•
The battery holder of the remote control is located at the back of the remote,
on the bottom. To replace the battery, press on the side of the battery cover
(1) and pull (2) to slide it open.
•
Replace the old battery with a new lithium battery type CR2025. Make sure to
use the correct polarity.
•
Push the battery holder back in the remote control until it snaps into place.
•
Remove the battery when the device is not in use.
Do not puncture or throw batteries in fire as they might explode.
Dispose of batteries in accordance with local regulations.
Keep the battery away from children.
12.
Technical specifications
camera
colour CCD camera with sapphire glass lens
viewing angle
illumination
operating temperature
cable
stainless reel with special gold point touch connector to camera
fibreglass cable
cable length
monitor
7" TFT LCD monitor
OSD display
video output
USB
recording format
storage medium
IR remote control
power supply
12VDC /1800mA adaptor (incl.)
Li-ion battery pack (6 x BIT18650F 220mAh, incl.)
remote control
dimensions
case
camera
cable reel
total weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic
medium or otherwise without the prior written consent of the copyright holder.
05/05/2010
CAMSET24
60°
8 white LEDs
-4°F ~ 113°F (-20°C ~ 45°C)
20m
1Vpp PAL @ 75 Ohms
AVI
USB device (not incl.)
1x 3V lithium CR2025 battery, incl.
52cm x 43cm x 19cm
Ø22mm x 153mm
Ø32cm
11kg
7
© 2008 Velleman Components nv