Noise And Vibration; Before Initial Operation - Flex MXE 1000 Instrucciones De Funcionamiento Originales

MXE 1000/MXE 1002/MXE 1200/MXE 1202/MXE 1602

Noise and vibration

Values for the A-weighted sound pressure level and for the
total vibration values can be found in the table on page 5.
The noise and vibration values have been determined in
accordance with EN 62841.
WARNING!
The indicated measurements refer to new power tools. Daily
use causes the noise and vibration values to change.
NOTE!
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 62841 and may be used to compare one tool
with another. It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained, the
vibration emission may differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the vibration exposure
level, it is also necessary to take into account the times when
the tool is switched off or running but not actually in use. This
may significantly decrease the exposure level over the total
working period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and
the accessories, keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear defenders at a sound pressure above 85 dB(A).
Overview (Figure A)
1 Mixer paddle
2 Gear head
3 Motor housing with 2 handles
4 Rating plate *
5 4.0 m power cord with plug
6 Impact guard and rest
7 ON/OFF switch
8 Locking button
9 Drive spindle
10 Speed preselector switch
(MXE 1200/1202/1602)
11 Gear selector switch
a) 2nd speed and spindle lock (MXE 1002/1202/
1602)
b) 1st speed and spindle lock (MXE 1200)
* not shown
Instructions for use
WARNING!
Before performing any work on the mixer, pull out the mains
plug.
CAUTION!
The mains voltage and the voltage specification on the rating
plate must match.

Before initial operation

 Unpack the mixer and check that there are no missing or
damaged parts.
Mounting/changing the mixer paddle
Tool without spindle lock (Figure B):
 Bolt the paddle onto the drive spindle (1.).
 Counterhold the drive spindle with an open-end spanner
AF 19 and tighten the mixer paddle with an open-end
spanner AF 22 (2.).
Remove in the reverse order.
Tool with spindle lock (Figure C):
 Press the lock and turn the gear selector switch in anti-
clockwise direction to
 Bolt the paddle onto the drive spindle (2.).
 Tighten the mixer paddle with an open-end spanner AF
22 (3.).
Remove in the reverse order.
Gear selection (Figure D)
(MXE 1002/1200/1202/1602)
CAUTION!
Only select gear with motor stationary.
 Press lock (1.) and turn switch in anti-clockwise direction
to the required stage (2.)
MXE 1200:
I Output stage
Spindle lock for changing mixer paddle
MXE 1002/1202/1602:
I Output stage with higher torque
II Output stage with higher speed
Spindle lock for changing mixer paddle
Regulating the speed (Figure E)
(MXE 1200/1202)
 To adjust the maximum working speed, set the speed
preselector switch to the desired stage.
Speed
Stage
1
2
3
(1.).
I II
210 320
325 490
530 780
10