Charging The Battery - Oregon LM300 Manual De Instrucciones

TROUBLESHOOTING :
Problem
Area of cut (battery
duration)not large
enough
Cutting blade not
rotating while
garden product
switched on
Excessive
vibrations/noise
No charging
procedure possible
The charge
control LEDs and
respectively, do
not light up after
inserting the mains
plug into the socket
20
Troubleshooting
Possible Cause
Height of cut too low
Grass too high
Grass wet or damp
Grass is dense
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Battery contacts contaminated
The battery is defective, due to
a disconnection in the battery
Mains plug of battery charger
not plugged in (properly)
Socket outlet, mains cable or
battery charger defective
Corrective Action
Increase height of cut and walk
slower
Increase height of cut and walk
slower
Wait until grass is dry and walk
slower
Increase height of cut, walk
slower and cut more frequently
Remove battery, remove safety
key
Clear obstruction (always wear
gardening gloves)
Remove battery, remove safety
key .
Tighten blade nut/bolt (15 Nm)
Remove battery, remove safety
key .
Tighten blade nut/bolt (15 Nm)
Clean the battery contacts (e .g .
by inserting and removing the
battery several times) or replace
the battery
Replace the battery
Insert mains plug (fully) into the
socket outlet
Check the mains voltage
and if necessary, have the
battery charger checked by an
authorized customer service
station for power tools
Oregon® Lawnmower Model LM300