Brita WD 3020 Manual De Instrucciones página 6

3.2 Step 2: Starting the BRITA Tap Cartridge
Status Indicator
The BRITA Tap Cartridge Status Indicator reminds you through
three different coloured flashing lights when to exchange the filter
cartridge.
A Commissioning:
Insert the enclosed battery (1x CR2032) into the appropriate
compartment of the BRITA Tap Cartridge Status Indicator. Mind
the print on the battery for correct implementation (fig. 4). All LEDs
should flash shortly. Close the compartment. Keep the Reset But-
ton pushed down for three seconds until a small green light flashes
three times at the top.
B Initial programming of the BRITA Tap Cartridge
Status Indicator:
Depending on the setting you chose for the filter head (step 1),
you will programm the BRITA Tap Cartridge Status Indicator as
follows (see fig. 5):
a Push the button on the right side (HARDNESS) to choose the
water hardness. If you push the button once, two yellow LEDs
will flash (default hardness setting: B). Then push the button until
your correct water hardness setting appears:
To choose the water hardness setting C, push the button until
one yellow LED flashes.
To choose the water hardness setting B, push the button until
two yellow LEDs flash.
To choose the water hardness setting A, push the button until
three yellow LEDs flash (see table below).
6
ENGLISH
1014662-002_GA_BRITA_Tap_CE.indb 6
b Push the button on the left side (CARTRIDGE) to set the car-
c To change a setting, simply push the button until the right
d Insert the BRITA Tap Cartridge Status Indicator into the BRITA
(fig. 4)
C How the BRITA Tap Cartridge Status Indicator works
To ensure optimal performance, you should change the filter car-
tridge on a regular basis. The BRITA Tap Cartridge Status Indicator
in the BRITA lever tells you when to change the filter cartridge.
D Signals
The three lights in the BRITA lever are only activated in the filtering
position. They indicate:
- Green light: The BRITA filter is working at optimum performance.
tridge you are using. If you push the button once, two yellow
LEDs will flash (default cartridge setting: P1000). Then push the
button until the correct setting for filter cartridge appears:
If you are using the filter cartridge A 1000, push the button, until
one yellow LED flashes.
If you are using the filter cartridge P 1000, push the button, until
two yellow LEDs flash.
If you are using the filter cartridge P 3000, push the button, until
three yellow LEDs flash (see table below).
n umber of lights are flashing.
tap's lever (see fig. 4).
water hardness setting (HARDNESS) C
cartridge setting (CARTRIDGE)
1. Cartridge Button
2. Hardness Button
3. Reset Button
(fig. 5)
1 LED 2 LEDs 3 LEDs
B A
A 1000 P 1000 P 3000
04.04.16 11:27