Dip Swtch - Asystems DMP81 Manual Del Usuario

DMP81
DIP SWITCH
DMP81 is equipped with two DIP switches on the rear panel, which is offering various setup options and for turning ON/OFF
the phantom power for each channel�
DIP Switch 1 (for adjusting setup options)
Switch Number
Auto /
Switch Function
Manual
Switch Up (On) Auto
Switch Down (Off) Manual
Manual/Auto: In Manual mode, DMP81 works as a
standard 8x1 mixer� In Auto Mode, the input drops by
3 dB every time the number activated inputs doubles�
When in MANUAL mode, the master output drops by 9
dB when all 8 channels are activated� And it will increase
by 9 dB when in AUTOMATIC mode�
Last Mic Lock-On: And only the most recently activated
channel will be enabled until the another channel is
enabled. When this function is turned off, channel
disables after the preset hold time�
DIP Switch 2 (for turning phantom power ON/OFF)
This DIP switch is used for turning ON/OFF the +48V phantom power for each channel� The number labeled under each
switch is corresponding to the channel numbers�
English
1 2 3
Last Mic Hold
Lock-on Time
Enabled 0�4 sec
Disabled 1�0 sec
4 7
Off-Att Limiter Threshold
7 Up
-15db = LIM off
8 Up
7 Down
∞
- =+8 dBm
8 Up
Hold Time: Adjusts the time an activated channel (which
is not locked on) remains on after the talker stops talking�
Settings are 0�4 seconds or 1�0 second�
Off-Attenuation: Adjusts the off-attenuation level from
15 dB to infinity (-∞). With the 15 dB setting, an unused
microphone is 15 dB lower in level than when it is
activated. With the -∞ setting, an unused microphone is
completely off.
Limiter Threshold: Adjusts the limiter threshold for
outputs� Settings are OFF, +16 dBm, +8 dBm, or +4 dBm�
4
8
7 Up
=+16 dBm
8 Down
7 Down
=+4 dBm
8 Down