Replacing The Battery - Velleman HOTSPOT Manual Del Usuario

7. How to Switch On the Gas Heater
Prior to using the gas heater for the first time or after the gas heater has been stored for a long time,
we recommend, with the pressure regulator closed, repeatedly pressing the buttons a few times.
The gas heater can be set to three heat positions: the maximum, the medium and the minimum position. The
ignition is generated by an electric spark.
Ignition of the Gas Heater
1. Open the gas flow by turning the lever of the pressure regulator toward the marking.
2. Turn the button to the
igniter button until the pilot light is lit.
3. Repeat this operation until the pilot light is lit.
4. Slowly release the button and turn to the maximum position until one of the burners is lit. As soon as the
two burners are lit, slightly press and turn the button to the desired position.
Remark
The heater may produce a slight white smoke with first use. To avoid any inconvenience, ignite the heater in a
well-ventilated room and let it burn for at least 5 minutes or until the heater does not produce any white
smoke.
8. Replacing the Gas Canister
1. Close the gas flow by turning the lever of the pressure regulator away from the marking.
2. Remove the canister from the heater.
3. Remove the regulator from the canister and install on the new canister.
4. Place the new canister in the heater without deforming the hose and close the access door.
9.

Replacing the Battery

The heater is equipped with a battery-powered igniter. To replace the battery:
1. Turn the igniter button in an anti-clockwise direction and remove the button.
2. Remove the old battery and replace with a new one, the positive pole facing upwards. Only use a fresh
alkaline LR6/AA 1.5 V battery.
3. Replace the button on the igniter and tighten.
Warning: Do not puncture batteries or throw them in fire as they may explode. Do not attempt to
recharge non-rechargeable batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.
V. 04 – 09/07/2018
HOTSPOT
position. Hold the button pressed for 5 to 10 seconds, while pressing the
4 ©Velleman nv