SHERCO CityCorp 125 Manual De Propietario página 10

C l u t c h l e v e r
1 2
10 to 15 mm
E n g i n e
2 1
Check the oil level (stop the engi
ne and wait a few minutes)
1. Stand the vehicle perpendicular to
the ground.
2. Remove the cap (2) and check the
oil level.
3. If the level is low add the correct
amount of the approved oil to
bring it to the correct level.
4. Replace the cap.
a d j u s t m e n t
There are two places to adjust the clutch cable:
one is on the lever and the other is on the cable
near the engine. This illustration shows the clut-
ch lever adjustment.
1. Loosen the lock nut (1).
2. Adjust the adjuster (2) until you obtain a free
play of approx. 10 to 15 mm.
3. Tighten the lock nut (1).
o i l
3
Oil change :
1. Warm up the engine and then shut
it off.
2. Place the vehicle over an approved
receptacle.
3. Remove the oil drain plug (3).
Note: the picture does not look like
the drain plug
4. Once the oil has completely drai
ned, replace the drain plug (3) and
torque it to 18 Nm.
5. Remove the cap (2) and fill the
engine with the approved amount
D r i v e c h a i n
1
To check the drive chain for slack:
1. The wheels have to be on the ground.
2. The motorcycle has to be vertical.
3. No one can be on the motorcycle.
If the vertical deflection is between 25 and 40 mm the chain must be adjusted.
1. Loosen the rear wheel axle nut (2).
2. Turn the chain adjusters (3) on both sides of the motorcycle until the chain
deflection is between 12 and 24 mm. Make sure that the adjusters are in the
same position on both sides.
3. Tighten the rear wheel axle nut (2) to 90 Nm.
We recommend that you lubricate the chain with chain lubricant.
SPRAY CHAIN REF. 704/702
a d j u s t m e n t
2 3
17