EYENIMAL PET FOUNTAIN Manual De Instrucciones página 6

User's guide
READ CAREFULLY ALL THE INSTRUCTIONS BEFORE USING THE DEVICE.
Lift the dome and remove it.
Put the water pump in the water without
linking it for the moment to the pipe.
Then move several times the
pump in the water from front to back to
empty the air off the pump.
Put the power cable in the zone cut at the
back of the base.
Fill in the dome with water and put the cap
again.
INSTALLATION
Lift the base of the dome and remove it.
Plug in to a standard power point to
activate the pump. Let the pump work 20-
30 seconds before going to the next step.
NOTE: Do not activate the pump before it is fully immersed
into the water. If the pump is not immersed into the water
before it is turned on, the pump sucks up air and may not
work properly.
Line up the posts with the tubes on the
base of the dome and fix the base.
Place the dome on the base in the
designed zone.
6
Fill in the bowl with water so that the water
level is between the MIN and MAX filling
lines.
Press the suction pads placed at the back
of the pump on the face of the pump.
Make sure that the pump is positioned
with the power cable on the top, as shown
on the picture.
Insert the rubber pipe in the pump water.
You should now see the water flowing
from the fountain.
Turn the cap of the dome counter-
clockwise and remove it.
The fountain needs
water constantly to work
properly. Each time the
bowl is out of water,
follow all the steps
above again.