Connecting The Unit - AEG DVK 4628 Instrucciones De Servicio

3D-преобразователь AEG DVK 4628
Купить в интернет-магазине http://clatronic-shop.com.ua
WARNING:
• Do not expose batteries to extreme heat or direct sunlight. Never throw batteries
into a fire. Risk of explosion!
• Keep batteries out of the reach of children. Batteries are not toys.
• Do not force open the batteries.
• Avoid contact with metallic objects (rings, nails, screws etc.). Risk of short circuit!
• Short circuits may cause the batteries to become very hot or even ignite. This may
cause burns.
• For your own safety, the battery terminals should be covered with adhesive strips
during transport.
• If a battery leaks, do not rub the liquid into your eyes or mucous membranes. If you
come into contact with the liquid, wash your hands, rinse out your eyes with clean
water, and seek medical advice if symptoms persist.
CAUTION:
Do not dispose of batteries with household waste. Please take used batteries to the
designated collection point or to a dealer.
Remote control range
To use the remote control, point it at the remote control sensor on the front of the unit.
Make sure that there are no obstacles between the remote control and the sensor. The
distance from the remote control to the sensor should not exceed 5 meters. The angle of
the remote control to the remote control sensor should not exceed 30° to the right, left,
top and bottom.

Connecting the unit

NOTE:
Trouble-free operation can only be guaranteed by use of audio/video cables of up to
1.5 m.
Connect HDMI cable
Connect the unit to your TV and the signal source (e.g. DVD-Player). You will need two
HDMI cables to do so.
• Connect the signal source with the 3D TV Box with a HDMI cable. To do so, plug one
end of the cable into the HDMI IN connector (16) on the back of the 3D TV Box.
English
55