Zibro Kamin R 59 C Instrucciones De Uso página 54

I
J
empty full
K
4
54
R 59 C
3 Take the manual fuel pump and insert the smooth, most rigid tube into the
jerrycan. Make sure that it is in a higher position than the removable tank
(Fig. I). Insert the ribbed hose into the opening of the removable tank.
Lock the valve on top of the pump (turn clockwise).
4
Squeeze the pump a few times, until fuel starts flowing into the removable
5
tank. As soon as this happens, there is no need to press any longer.
Check the removable tank fuel gauge µ while filling the tank (Fig. J). Stop
6
filling by loosening the valve on top of the pump (turn anti-clock-wise), once
the gauge indicates that the tank is full. Never overfill the tank, especially not
when the fuel is very cold (fuel expands when it heats up).
Let the remaining fuel in the pump flow back into the jerrycan and carefully
7
remove the pump. Carefully screw the fuel cap back on the tank using the
fuel cap cover (Fig. H). Clean off any spilled fuel.
8 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
IGNITING THE HEATER
A new heater may give off some smells for a short while, when it is used for the
first time. You should therefore provide extra ventilation or ignite the heater
outside the living room.
When you use the heater for the first time, first put the filled removable tank into
place, and then wait approximately 30 minutes before you ignite the heater. This
allows the glass fibre wick to soak up the fuel. Follow the same procedure when you
have completely burnt up all fuel from the tank, and after the glass fibre wick has
been replaced.
Prior to igniting the heater, always check the fuel indicator ² for sufficient fuel in
the removable tank. Green = full, red = empty.
Always ignite the heater with the igniter slide. Never use matches or cigarette lighters.
Follow the procedure below:
1 Open the door
Slowly push down the igniter slide » together with the flame regulator ·
2
(Fig. K). At the same time you will activate the safety device.
Release the ignition slide as soon as a flame is visible at the bottom of the
3
combustion chamber ¿.
Close the door.
4
at the front of the heater.