Cleaning And Maintenance; Troubleshooting - Global Industrial 641164 Manual Del Usuario

1. Remove stainless steel
cover by unscrewing
counter-sink socket head
screw using hex key.
(provided).
Knock
out hole
2. Punch out knock out hole for the power supply wires.
Determine wall mounting location and mark hole locations
with screw holes in the dryer. Use a 0.1875" drill bit and drill
4 holes 1" deep. Insert plastic anchors flush to wall. Feed
power supply wires through knock out hole. Place dyer
against wall and tighten screws using #9 x 1" Lg. phillips
screws. (provided).
High Velocity Automatic Hand Dryer
3. Connect wires into the terminal. Connect Live wire to
terminal block marked "L". Connect Neutral wire to the
terminal block marked "N". Connect Ground wire to the
terminal block marked
4. Replace and secure front cover with counter-sink socket
head screw. Do not over-tighten.
5. Switch on circuit breaker to test unit. If dryer does not
operate, refer to Troubleshooting.
OPERATION
1. No touch operation.
2. Shake excess water from hands.
3. Place hands under outlet to start operation.
4. Rub hands lightly and rapidly.
5. Stops automatically after hands are removed.

CLEANING AND MAINTENANCE

1. Disconnect electrical supply.
2. Remove the two cover-mounting screws.
3. Remove cover.
4. Clean all dust and lint from dryer interior.
5. Wipe cover with damp cloth or mild cleaning solution.
Do not soak. Never use abrasives to clean cover.
6. Replace cover. Do not over tighten screws.

TROUBLESHOOTING

PROBLEM
The dryer does Check that breaker supplying dryer
not run. power is on and working.
If working, disconnect the power
and verify that wiring is correct.
If wiring is correct, dryer may be
too close to counter (less than 15")
or an object may be below infrared
sensor. Remove object or relocate
the dryer.
The dryer Ensure that there is no obstruction
cycles by on or below infrared sensor. Clean
itself or runs any dirt or debris from sensor lens.
constantly.
The infrared Ensure that there is no obstruction
sensor only on or below infrared sensor. Clean
"sees" close any dirt or debris from sensor lens.
range objects.
4
User's Manual
L
N
.
SOLUTION