Publicidad
Idiomas disponibles
Idiomas disponibles
Any damaged protection devices should be repaired or
replaced by an authorised person unless the operating
manual states expressly otherwise.
An authorised workshop should replace any
defective/faulty switches. Any repairs should be referred
to your local servicing centre.
9.
Use approved spares only. Use only genuine spare
parts for repairs and maintenance. Request the spare
parts from a respective servicing centre only.
Warning! Use of accessories and extensions other than
expressly recommended may imply a personal and material
risk.
The unit is allowed to be used for the specific purpose only.
Any deviation will be considered an unauthorized use The
user only – and not the manufacturer – shall be held liable for
personal injuries and material damage arising from such an
unauthorized use.
The manufacturer shall not be held liable for any damage
resulting from unskilled changes of the unit or an unqualified
use.
Supplementary Safety Rules
Before performing any maintenance, inspection and
•
cleaning away the sand blast cabinet is always from the
compressor.
Make the operating manual available to anybody
•
working with the unit.
•
Never use the unit with the cover opened.
•
Work only with the pressure recommended in this
manual.
Operate the unit only with the fitted gloves.
•
•
Use only the proper blasting material.
•
Make sure that the lighting is appropriate.
Be careful to wear appropriate working clothing.
•
Only the persons of age should use this unit. Apprentice
•
of 16+ years of age may use it under supervision of
adults.
In the course of the unit use, children, the sick and infirm
•
should be kept away.
•
Check the unit for damage. Do not use it if it shown
defects or is damaged.
Have the unit repaired by an authorised servicing centre.
•
•
Do not attempt any repairs by yourselves. Only an
authorised servicing centre may do the repairs and parts
replacements.
•
Where practicable, any person working with this unit
should not be disturbed.
The unit protection devices should never be removed or
•
made duff.
•
Damaged or defective protection devices should be
replaced immediately.
If you are disturbed while working with the unit, realise
•
the situation before you pay attention to a new one.
•
Check any screws, nuts and other joints for tightness at
regular intervals.
•
Never store tools or materials above the unit so that a
fall on the unit could be possible when trying to reach
them.
Always disconnect the compressed air and power supply
•
to remove a fault.
•
Any adjustment, measurement, cleaning etc. may not be
done unless the compressed air and power supply is
interrupted.
•
Never leave your workplace unattended.
If any repairs or maintenance is done on the safety
•
devices, these should be re-installed immediately after
the works are completed.
•
It is an unconditional requirement for you to familiarise
yourself with any safety regulations and accident
preventions as well as the general safety rules applied in
the place of the unit use.
•
Check the unit regularly to see that it does not show any
signs of damage.
•
You should test any of the protection devices before the
use of the unit. Make sure to see that any damaged
parts work properly even if the damage seems to be
negligible.
•
Check any of the moving parts to see that they work
perfectly. Be particularly careful about damage or
jamming of the moving parts. All the parts have to be
installed correctly and any conditions of perfect function
of the unit should be met.
Unless otherwise stated in this manual , any damaged
•
parts and safety devices should be repaired/replaced by
an authorised servicing centre.
Have the damaged switch replaced by an authorised
•
servicing centre.
•
This unit is in compliance with any relevant safety
provisions. Repairs should be done only by qualified
electricians at an authorised servicing centre and only
the original spare parts should be used. If this provision
is not observed, the risk of accidents is imminent.
Do not use the unit when your attention is reduced or
•
you are affected by alcohol or drugs or tired.
Behaviour in case of emergency
Provide necessary first aid treatment corresponding to the
injury nature and seek qualified medical help as soon as
possible. Protect the injured person from other injuries and
calm him/her down.
First aid kit must always be available in the place of your
work in case of accident in accordance with DIN 13164.
Material taken out of the first aid kit needs to be
supplemented right away.
If help is needed, please provide the following details:
1.
Place of accident
2.
Accident nature
3.
Number of injured persons
4.
Injury type
Assigned Use
For Sans rays of small to medium metal parts. It is very
important to the compressor, shall be blasted with, according
to size large. The sandblasting gun consumes approximately
200-600 l / min., Ie it takes at least a compressor with to
achieve 50 l and 300 l suction tank for optimum results.
The device cannot be used for works other than for which the
device has been designed and that are specified in the
Operating Instructions. Any other use is a use in conflict with
the designation. The manufacturer will not be held liable for
any consequential damage and injuries. Please be sure to
know that the device has not been designed for industrial
purposes.
Disposal
The disposal instructions are based on icons placed on the
device or its package. The description of the meanings can be
found in the "Marking" section.
Transport package disposal
The package protects the device against damage during
transport. Packing materials are usually chosen depending
on their environmental friendliness and disposal method and
can therefore be recycled. Returning the package to material
circulation saves raw materials and reduces waste disposal
costs. Parts of packages (e.g. foils, styropor®) can be
dangerous to children. Risk of suffocation! Keep parts of
the package away from children and dispose them as soon as
possible.
14
Publicidad
