Danfoss TP9 Instrucciones Del Usuario página 19

Before you change the preset programme
Your installer will have set your unit to operate in either 24 hour
mode or 5/2 day mode.
To tell which mode your unit is set press PROG until Event 1 fl ashes
in the display.
Please Note
The unit must be programmed in sequence - ON/OFF times
cannot be programmed out of sequence
If you want to leave a preset time as it is, simply press PROG
to move on to the next setting.
!
If at any time you get confused and need to reset the unit to
the preset programmes, press and hold the four buttons
, - and + simultaneously (see page 17.)
If your display looks like this, your unit is in
24 hour mode and you can enter one set of
programmes for the whole week (see page
20).
If your display looks like this, your unit is in 5/2 day
mode and you can enter one set of programmes
for weekdays and another set for weekends
(see page 21-22).
GB
,
19