SYNQ PCM.1 Manual De Instrucciones página 4

ENGLISH
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
INSTALLATION GUIDELINES:
 Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity.
 Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc.
will affect its performance and may even damage the unit.
 The unit can be mounted in 19-inch racks. Attach the unit using the 4 screw holes on the front panel. Be
sure to use screws of the appropriate size. (screws not provided)
 Take care to minimize shocks and vibrations during transport.
 When installed in a booth or flight case, please make sure to have good ventilation to improve heat
evacuation of the unit.
 To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when
bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full
performance.
CLEANING THE APPLIANCE:
Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside the unit. Do not
use volatile liquids such as benzene or thinner which will damage the unit.
CONNECTIONS
The PCM-1 can be connected in different ways, below are the two most common:
STANDALONE SETUP
 Connect the output named "mixed output"
to your amplifier
 Connect a headphone (if needed for
monitoring)
 Connect the supplied USB cable between
the USB-output of the controller and one
of the USB-connectors on your PC or
laptop.
 Connect the supplied AC/DC power
adapter and switch the controller on
 Install the Deckadance PC-software from
the CDROM.
Please refer to the "software installation &
setup manual" on the CDROM for more
information about the installation and
configuration of the Deckadance PC-
software. When the software is installed on
your PC, you should just refer to the setup
panel here to see how the PCM-1 should be
configured for standalone operation.
SYNQ
®
OPERATION MANUAL
3/48 PCM-1 MIDI CONTROLLER
ENGLISH
EXTERNAL MIXER SETUP
 Connect the "player1" audio output to a
line input of your mixer.
 If fader start is needed use the supplied
fader start cable to connect the "control
start" output of player1 with the
corresponding fader start input of your
mixer.
 Connect the "player2" audio output to
another line input of your mixer.
 If fader start is needed use the supplied
fader start cable to connect the "control
start" output of player2 with the
corresponding fader start input of your
mixer.
 Connect the supplied USB cable between
the USB-output of the controller and one
of the USB-connectors on your PC or
laptop.
 Connect the supplied AC/DC power
adapter and switch the controller on
 Install the Deckadance PC-software from
the CDROM.
Please refer to the "software installation &
setup manual" on the CDROM for more
information about the installation and
configuration of the Deckadance PC-
software. When the software is installed on
your PC, you should just refer to the setup
panel here to see how the PCM-1 should be
configured for operation with an external mixer.
SYNQ
®
OPERATION MANUAL
4/48 PCM-1 MIDI CONTROLLER