Rear Panel Description - Phonic POWERPOD 410 R Manual Del Usuario

REAR PANEL DESCRIPTION

15. POWER SWITCH
This switches the powered mixer on and off. While turn it on, the
power on blue LED indicator will light up on the master section
of front panel.
16. SPEAKER OUTPUT JACKS
Speakers can be connected to these sockets. Two speakers
can be connected to the powered mixer at any one time. When
using 2 speakers at the same time, ensure they are between 8
and 16 ohms. When using one speaker only, the speaker should
be between 4 and 8 ohms speaker. The total minimum required
load is 4 ohms. If the total load is less than 4 ohms, it may dam-
age this powered mixer.
17. TAPE IN AND REC OUT
The RCA TAPE In jacks allow cassette recorders or CD players
to be added to the Main output. The RCA RECORD OUTPUT
jacks provide signal output to a cassette deck or other home
audio equipment. The nominal output level and impedance are
-10dBV/600ohms.
18. MAIN OUT / AMP IN
This unbalanced insert point is a break between the main out and
built-in amplifier to allow the main output to be sent to an external
signal processor or power amplifier. The insert is a 1/4" phone
jack socket which is normally bypassed. The signal path is broken
when a jack is inserted.
The main output signal appears on the TIP of the plug and the
external signal is returned on the RInG. A "Y" lead may be required
to connect to equipment with separate send and return jacks as
shown below:
6
15
16
18
17
POWERPOD 410
R