Installation; Connection Cable - AEG HK884406XG Manual De Instrucciones

E4 comes on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
rect built-in units and work surfaces
that align to the standards.
Problem Possible cause
There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones
and the Automatic
Switch Off operate.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.

8.2 Connection cable

• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable on-
ly with the spare parts cable. Speak to
your local Service Centre.
Two phase connection
1.
2.
3.
Remedy
Deactivate the appli-
ance. Remove the hot
cookware. After approxi-
mately 30 seconds, acti-
vate the cooking zone
again. If the cookware
was the problem, the er-
ror message goes out of
the display, but the re-
sidual heat indicator can
stay. Let the cookware
become sufficiently cool
and refer to "Cookware
for the induction cooking
zones" to see if your
cookware is compatible
with the appliance.
Remove the cable end sleeve from
black and brown wires.
Remove insulation of the brown and
black cable ends.
Apply a new wire end sleeve of 1.5
mm² on each cable end. (Special
tool required)
WARNING!
All electrical connections must
be made by a qualified electri-
cian.
ENGLISH
15