Safety Instructions - D-Link DCS-1201 Guia De Instalacion

SAFETY INSTRUCTIONS

Please adhere to the following safety guidelines to help ensure your own personal
safety and protect your system from potential damage. Any acts taken that are
inconsistent with ordinary use of the product, including improper testing, etc., and those
not expressly approved by D-Link may result in the loss of product warranty.
Unless expressly approved by an authorized representative of D-Link in writing, you
may not and may not permit others to:
• Disassemble or reverse engineer the device or attempt to derive source code
(underlying ideas, algorithms, or structure) from the device or from any other
information provided by
D-Link, except to the extent that this restriction is expressly prohibited by local law.
• Modify or alter the device.
• Remove from the device any product identification or other notices, including
copyright notices and patent markings, if any.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the device and
other equipment, observe the following precautions:
Power Sources
• Observe and follow service markings.
• Do not push any objects into the openings of your device unless consistent with
the authorized operation of the device. Doing so can cause a fire or an electrical
shock by shorting out interior components.
• The powering of this device must adhere to the power specifications indicated for
this product.
• Do not overload wall outlets and/or extension cords as this will increase the risk of
fire or electrical shock.
• Do not rest anything on the power cord or on the device (unless the device is
made and expressly approved as suitable for stacking).
• Position system cables and power cables carefully; route cables so that they
cannot be stepped on or tripped over. Be sure that nothing rests on any cables.
• Operate the device only from the type of external power source indicated on the
electrical ratings label.
• To help avoid damaging your device, be sure the voltage selection switch (if
provided) on the power supply is set to match the power available at your location.
• Also be sure that attached devices are electrically rated to operate with the power
available in your location.
• Use only approved power cable(s). If you have not been provided a power cable
for your device or for any AC-powered option intended for your device, purchase
a power cable that is approved for use in your country and is suitable for use with
your device. The power cable must be rated for the device and for the voltage and
current marked on the device's electrical ratings label. The voltage and current
rating of the cable should be greater than the ratings marked on the device.
• To help prevent an electrical shock, plug the device and peripheral power cables
into properly grounded electrical outlets. These cables are equipped with three-
prong plugs to help ensure proper grounding. Do not use adapter plugs or remove
68
D-Link DCS-1201 Quick Installation Guide