Burda TERM2000 IO IP67 Serie Instrucciones De Montaje página 12

GB
GB
Description of remote-control panel
a: Weak battery LED
b: Channel selection indicator LEDs
c: Select, Channel select switch
d: Variation dial
e: Auto/man mode selector
f: Wall mount
g: Power ON
h: key MY;
i: Power OFF
j: Wall mount recess
k: PROG button
l: EDs 1,2,3,4 (operating mode indicator LEDs)
m: perating mode select button
n: Autonomous mode selector button. It will not be operated when using our IO heater
o: Battery Cover and setting buttons
Please observe the safety and warning instructions of the SOMFY radio user manual
2. Operating mode
2.1. Select the channel for the heater by the button
"SELECT". The factory default set channel 1 for heaters.
Totally 5 channels are available for selection.
2.2. Unclip the battery cover;
2.3. Press the button (E) as shown in the right diagram.
-Press the button once, the LED will be switch to 1, 2, 3,
4 in successively.
Caution! Please set the remote control in the operating mode 2
(LED 2 lit) that is used to control and vary the heating.
2.4. Clip the battery cover back on.
2.5. Press the button UP and DOWN simultaneously,
Until the lamp is ON/OFF in one cycle.
2.6. Briefly press the PROG button:
the lamp is ON/OFF one time, to indicate that the
remote control had been matched with the heater;
3. Restoring the IO to the original configuration
Caution!
This reset removes all remote controls.
Adding a new remote control please refer to the clause 2.5 and 2.6.
3.1. Switch the power off 2 seconds;
3.2. Switch the power on 10 seconds (more than 5 seconds and
less than 15 seconds)
3.3. Switch the power off 2 seconds;
3.4. Switch the power on.
The lamp will be ON and OFF one cycle. The symbol
means one cycle of lamp ON/OFF
3.5. Press the button "PROG" uninterruptedly until the lamp is ON/OFF in the first cycle, and the lamp
is ON/OFF in the second cycle, and then release the button "PROG". Now add a new remote
control. The same as 2.5 and 2.6.