HAir dryer
this hairdryer is very simple to use, but please read these
instructions carefully before using.
environment friendly disposal: You can help protect
the environment! please remember to respect the local
regulations: hand in the non-working electrical equipments
to an appropriate waste disposal center.
iMPOrTANT iNFOrMATiON ON iNSTALLATiON
in order to switch off in the event of a fault, the electrical
installation must conform to regulations. in this regard, the
device must also be protected with a corresponding fuse
and should not depend directly on the mains.
•
For installations in the bathroom, it is advisable that the
residual current device switches off from a fault current
of 30ma.
•
In case of doubt, please consult a qualified technician.
•
For installations in the bathroom, the location of the
installation is also very important.
•
The device should not be in contact with water.
•
We recommend the "volume range 3" for the installation
as shown in the figure.
iNSTALLiNg THe WALL BrACKeT
1. the mains cable must remain unplugged during the
installation.
2. remove the cover.
3. place the bracket on the wall and mark the desired
position for the holes (make sure to use the correct size
of drill bit).
drill 35mm deep and then put the dowels in the holes.
4. Now, screw the wall bracket firmly onto the wall.
5. attach the cover again, then you can plug in the mains
cable.
HOW TO USe yOUr HAirdryer
1. connect the plug to the power supply network.
2. the appliance is switched on by pressing the on/oFF
switch (a).
3. use the high setting for drying hair, use low setting for
styling.
2
4. should the hair dryer stop for any reason, turn it off at
once and let it cool down.
WArNiNg: compare the local voltage with the voltage
declared on the device.
deSCriPTiON OF THe SWiTCH-POSiTiON
A: on/oFF by integrated handle
switch
B:
: cool air Flow: for
finishing your styling
1:
Warm Air Flow: for gentle
drying and styling
2:
hot air Flow: for quick
drying
CLeANiNg ANd CAre
iMPOrTANT:
always ensure that hair dryer is disconnected from the
mains supply before cleaning.
use a damp cloth for cleaning and wipe dry. this will help
preserve the original finish of your hair dryer.
abrasive cleaners should not be used.
WArNiNg:
never immerse the hair dryer in water and always ensure
that plug is kept dry.
Frequently clean out any hair or fluff that becomes stuck
in the inlet filter. To clean the filter, vacuum or dry brunch
clean, never immerse the filter in water. Failure to keep
filter clean may result in overheating.
iMPOrTANT SAFegUArdS
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed, including the following:
reAd ALL iNSTrUCTiONS BeFOre USiNg
dANger – To reduce the risk of electrocution:
1. always unplug this appliance immediately after using.
2. do not use while bathing.
3. do not place or store appliance where it can fall or be
pulled into a tub of sink.
4. do not place in or drop into water or other liquid.
5. do not reach for an appliance that has fallen into water.
unplug immediately.
WArNiNg – To reduce the risk of burns, electrocution,
fire of injury to persons:
1. an appliance should never be left unattended when
plugged in.
2. close supervision is necessary when this appliance is
used by, on, or near children or invalids.
B
a
3