Stopping Ice Cube Production - Silvercrest SEMK 105 A1 Instrucciones De Uso

NOTE
The first production phase may last a little longer than the following ones .
►
The ice cubes do not reach full size until around the third production
►
phase, depending on the water and ambient temperature .
The production time is dependent on the water and ambient temperature .
►

Stopping ice cube production

WARNING
Drain the water from the water tank
►
Otherwise, bacteria can start to build up!
Press the
♦
green .
To switch off the appliance completely, remove the ice cubes and pull the
♦
plug from the mains power socket .
Allow the appliance to defrost and check whether there is any water left in
♦
the rear part of the appliance . To do this, tip the appliance slightly forwards
so that the water runs into the water tank
To let the water out of the water tank
♦
it juts out over the edge of the worktop and you have access to the drain
opening
front feet still have a firm foothold .
Hold a container that is suitably large to hold the expected amount of water
under the drain opening
Once the water has drained out, push the cap firmly back into the drain
♦
opening
SEMK 105 A1
button to stop ice production . The control lamp
on the underside of the appliance . Ensure, however, that the
and pull out the cap .
.
after a maximum of 24 hours .
.
, pull the appliance forward so that
GB │ MT
flashes
│ 47 ■