Installation Information - DURAVIT Inipi Instrucciones De Montaje

Important information
About the mounting instructions
These mounting instructions come as part of the Duravit
Sauna and should be read carefully prior to the
installation.
Explanation of the key words and symbols
DANGER! At high risk of fatal hazards or
serious injuries
NOTE! To avoid property damage
Link to the Electrical Installation section
Link to the installation information in this
section
Inspection (e.g. for scratches)
5
4
3
2
1
1
Link to box number
Target group and qualification
The sauna must only be installed by trained plumbing
engineers. The electrical installation may only be carried
out by qualified electricians.
NOTE!
Local installation regulations and any country-specific
standards must be observed at all times.
Safety instructions
DANGER! Risk of fatal electric shock.
> Do NOT remove individual sauna components.
6
SAUNA_M_Inipi/15.09.14

Installation information

Please read pre-installation data sheets prior to the
installation. These are available to download on the
Internet at www.duravit.com.
Minimum clearances
The minimum clearances to the structure must be ob-
served to ensure the optimum function of the sauna and
to avoid damage to the structure.
Front 1000 mm
Side 25 mm
1
Checking the surfaces (Diagram 1)
> Check the surfaces for scratches and damage
after unpacking and removing the protective film.
> Always place the cardboard underneath after
unpacking to protect the surfaces from any
damage.
46
Inserting the sauna stones (Diagram 46)
> Wash the sauna stones thoroughly under running
water.
> Insert the sauna stones into the stone container
in such a way that the convection air flow can
circulate well between the stones:
Insert the stones loosely and fill the container
up to the rim (The delivery includes more than
the quantity required)
No not insert any broken stones (Ø < 35 mm)
55
Connecting the cable (Diagram 55)
> Connect the cable according to the labelling.
> Connect an external antenna cable if necessary.
70
Securing the flat leaf screws (Diagram 70)
> Screw in the flat leaf screws with a clearance
of approx. 1 mm to the wall so that there is no
damage to the wall.
82
Securing the seats (Diagram 82)
> First of all, screws in all plastic screws of one
seating level, then tighten the screws definitively.
92
Attaching the seals (Diagram 92)
> Moisten the seals and then push them in.
Top 130 mm
Bottom 20 mm