Connecting The Hob To The Mains Power Supply - Viesta I2Z Manual De Instrucciones

KEN001AKI
Installation
Cautions
1. The induction hotplate must be installed by qualified personnel or
technicians.
Do not install yourself, as your warranty expires immediately when not
properly installed.
2. The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics
3. The induction hotplate shall be installed such that better heat radiation can be
ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.

Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a
suitably qualified person.
Before connecting the hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob.
2. the voltage corresponds to the value given in the rating plate
3. the power supply cable sections can withstand the load specified on
the rating plate.
To connect the hob to the mains power supply, do not use adapters,
reducers, or branching
devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be
positioned so that its temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is
suitable without alterations. Any alterations must only be made by a
qualified electrician.
[English]
[ 27 ]
18.09.2017 • v09