Controls And Functions - Mx Onda MX-EZ2230 Manual De Instrucciones

CONTROLS AND FUNCTIONS

1. Pressure cone
2. Big cone
3. Small cone with blades
4. Strainer
5. Container with direct discharge
outlet and drip system
6. Base with cable collection
7. Pressure lever
8. Hole to accommodate the pressure
cone
REMOVING AND ASSEMBLING THE CITRUS JUICER
To removing and assembling the citrus juicer (for cleaning the juicer, for
example), follow these steps:
1. Fully raise pressure lever 7.
2. Hold the pressure cone and press lightly on the pressure cone holder 8,
located in the middle of the pressure lever. The pressure cone will be
ejected.
3. Remove the large cone and small cone assembly with blades 2 and 3.
4. Then pull up strainer 4.
5. Remove the container with direct discharge outlet 5.
6. To install the juicer, proceed to place the different elements that make up
the juicer in reverse to the disassembly.
Note:
To place the pressure cone on the pressure
lever, you must match the two guides located
in the pressure cone in the groove of the hole
8 of the pressure lever. In the event that the
pressure cone is not correctly coupled to the
lever, it will not be retained.
8
5
Guides