Dmx-512 Connection; Control Panel Navigation - Velleman HQ-Power EXPLIO III - CABEZA MÓVIL - 12 X LED RGBW DE 10W Manual Del Usuario

norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

For truss mounting, use an appropriate clamp (not included) and fit an M10 bolt through the centre
of the (folded) bracket.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

Make sure there is no flammable material within a 0.5 m radius of the device.

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. All devices must be powered directly off a
grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or
dimmer channel is used solely for 0 % to 100 % switching.

The device has a power output to supply power to another device. When connecting several devices
in a daisy chain via this output, make sure that the total current does not exceed the power line‟s
nominal current. Use power cables with an adequate section. If you do not use the power linking
feature, be sure to use the included screw-on cap to prevent any water from getting into the power
cords.

The installation has to be approved by an expert before the device is taken into service.

DMX-512 Connection


When applicable, connect an XLR cable to the female XLR output of a controller (not included) and
the other side to the male XLR input of the device. Multiple devices can be linked through serial
linking. The linking cable should be a dual core, screened cable with XLR input and output
connectors.

Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended
number of devices on a serial data link is 32 devices.

A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket of the last device in
the chain.
7. Operation
The device can be used in the following modes:

stand-alone mode (with the built-in microphone)

stand-alone mode

sound-activated

stand-alone mode: automatic or sound-activated

master/slave

with a DMX512 controller.
7.1

Control Panel Navigation

Access the control panel functions using the four panel buttons located directly underneath the display.
From left to right:
Button Function
<MENU> used to access the menu or to return to a previous menu option
<DOWN> scrolls through the menu options in ascending order
<UP> scrolls through the menu options in descending order
<ENTER> used to select and store the current menu or option within the menu
V. 01 – 18/02/2013
VDPL1210MHRGBW
5 ©Velleman nv