Depth Adjustment - Makita DST221 Manual De Instrucciones

The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION

Depth adjustment

► 1. Nut
If the staples are driven too deep or too shallow, adjust
the driving depth by turning the nut on the bottom of the
tool. For deeper driving of staples, turn the nut clock-
wise. For shallower driving, turn the nut counterclock-
wise. Please note the nut must be turned in increments
of 90° (1/4 turn) so that the groove on the nut runs
parallel to the magazine.
1
7 ENGLISH
Driving staples
1
► 1. Front 2. Workpiece 3. Rear
Place flat the opening of the tool from which staples
are fired on the material to be fastened and hold the
tool firmly against the material. Then pull the lever and
then pull the trigger fully to drive the staples. The grip is
shaped so that the tool head can be held down securely
with index finger and thumb. After driving a staple, be
sure to release the trigger fully.
When the head of driven staple remains above the
surface of material to be fastened, drive the staple while
holding the stapler head firmly.
NOTE:
• Using the stapler continuously with the head
of driven staples remaining above the surface
of material to be fastened may cause damage
to the driver of the stapler and stapler jamming
etc..
3
2