Cleaning - Disinfection - Drying - Storage - RSG Safety 300 Serie Instrucciones De Uso

RSG Half Mask A5 User Manual June12 aw:Layout 1 12/06/2012 13:31 Page 7
CLE NING-DISINFECTING-DRYING-STOR GE
CLEANING:
It is recommended that the mask be cleaned after use. Clean the mask and the other
components (except the filters), in lukewarm water to which a mild detergent has been
added (e.g., washing-up liquid or a liquid washing machine detergent) which does not
contain perborate. If the mask is very dirty, a brush can be used to clean it. Do not use
solvents (e.g., benzine or spirit) or very warm water (max. 60°C). The mask should be
rinsed thoroughly in lukewarm running water (refer to cleaning intervals in table 3, page
8).
DISINFECTION:
Disinfect the mask components in a suitable solution after use. Use a disinfectant such
as "MULTIDOR". Follow the instructions carefully (refer to disinfection intervals in table
3, page 8).
DRYING:
RSG HALF MASK should be air-dried or dried in a drying cabinet at a temperature not
exceeding 60°C. Avoid direct sunlight.
STORAGE:
Store RSG HALF MASK in airtight and light-proof packaging in a cool and dry place.
NOTE!
Silicone has a tendency to absorb detergents and disinfectants. Irritation of
the skin can occur as a result.
Therefore:
1. Reduce the time the substances are in contact with the mask, which is
stated in the instructions, to a minimum.
2 Rinse thoroughly in running water for 10 minutes, after cleaning and
disinfection of RSG HALF MASK 30 01 01.
(GB) 6
© copyright 2018