Operation; Power Supply; On/Off Switch - RIDGID R4141 Manual Del Operador

ASSEMBLy
 Depress the spindle lock and rotate wheel bolt until the
spindle locks, preventing shaft from rotating.
 Using the arbor wrench provided, loosen and remove
wheel bolt.

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
WARNING:
Do not attempt to cut wood or masonry with this
cut-off machine. Never cut magnesium or mag-
nesium alloy with this machine. Failure to comply
could result in serious personal injury.
WARNING:
Never install any wood cutting blade on this
machine. The cut-off machine is properly guarded
only for cutting metal with an abrasive wheel.
Failure to comply could result in serious personal
injury.
WARNING:
Always use the vise clamp on the cut-off machine
to prevent accidents that could result in possible
serious personal injury.
NOTE: Wheel bolt has right hand threads. Turn wheel
bolt counterclockwise to loosen.
 Remove wheel bolt, washer, outer flange, and wheel.
WARNING:
Large, circular, or irregularly shaped material may
require additional means of clamping to be secured
in place adequately for cutting. Use "C" clamps
that can be mounted along the left and front side of
the machine base. Also use blocks to hold material
securely. Failure to comply could result in serious
personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Cutting all types of metals such as 2 in. x 6 in. steel
framing studs
 Cutting hard metal iron stock such as square bar stock
and angle iron
 Cutting metal tube and pipe stock

POWER SUPPLy

Before operating the cut-off machine, check the power
supply and make sure it meets the requirements listed on
the tool's data plate. A substantial voltage drop will cause a
loss of power and machine overheating.
Common causes of power loss and machine overheating are
insufficient extension cord size and multiple tools operating
from the same power source.

ON/OFF SWITCH

To turn the cut-off machine ON, depress the on/off switch
located in the handle portion of the machine arm.
To turn it OFF, release the on/off switch.
CUTTING WITH THE CUT-OFF MACHINE
See Figures 7 - 8, pages 19 - 20.
A cut-off is made by cutting across the width of the material.
A straight cross cut is made with the adjustable fence set at
the zero degree position. Angled cut-offs are made with the
adjustable fence set at some angle other than zero.
 Loosen the miter lock handle securing the fence.
 Rotate the adjustable fence to the desired angle.
 Retighten miter lock handle securing fence.
11 - English