Electric Heater; Troubleshooting - Global 653579 Manual Del Usuario

SPECIFICATIONS
(all specifications +5/-10 tolerance)
Voltage
Hertz
Wattage
Amp
Plug Type
BTU/Hour
OPERATING INSTRUCTIONS
1. Place the unit on a stable, level surface.
2. Plug the unit to grounded receptacle.
3. Turn on the unit using control knob.
CONTROL KNOB SETTINGS
Fan Only
Off High Heat
Control Knob
Problem
Heating element does Heating element is made of stainless steel
not glow. and will not glow red.
1. There is no power to the unit.
There is no heat or 2. Thermostat reached desired
air flow.
3. Temperature cut-off opened.

Electric Heater

120V
60HZ
1500W
12.5A
Nema 5-15P
5120
Thermostat

TROUBLESHOOTING

Cause
temperature.
4. Set the thermostat dial to the maximum temperature,
heater will run continuously.
5. Once the room reaches the desired temperature, dial
back until heating element turns off ( you will hear
click). The heater will now cycle on and off around this
temperature. To increase the temperature, turn the knob
clockwise. To lower the temperature, turn the thermostat
counterclockwise.
Note: The fan will constantly be on so that the thermostat
can detect ambient temperature.
AUTOMATIC OVERHEAT SAFETY CUT-OFF
This Heater is equipped with an internal overheat cut-off.
This is to protect the heater during abnormal situation
which can lead to overheating. When a potential
overheat temperature is reached, the heating element will
automatically shut off while the fan will still be on. Unplug
the heater and allow to cool down for 10 minutes then
restart.
Note: The fan will still be on to help cool down after
temperature cut-off opens.
CLEANING AND MAINTENANCE
1. Before cleaning, unplug the unit.
2. Clean the housing with with wet soft sponge or towel.
3. Do not splash water onto the unit and never use solvents
like gasoline, isoamyl acetate, toluene, and etc.
4. DO NOT open the heater to clean interior.
Heat is operating correctly.
1. Make sure unit is plugged and there is electricity.
2. Thermostat will shut off heating element once desired
temperature reached.
3. Unplug the heater and let it cool down for
10 minutes.
2
User's Manual
Solution